OPERATING INSTRUCTIONSSPEAKER SYSTEMS HX-5BHX-5WHX-5B-WPHX-5W-WPThank you for purchasing TOA's SpeakerSystem. Please carefully follow the instruc
10Step 2. For vertical suspension: Remove the 2 front bar fixing bolts. (Below, upper)For horizontal suspension: Remove the 4 front bar fixing bolts.
11Step 3. Fix the suspension bracket and the front bar with the bolts removed in step 2.Step 4. For vertical suspension: Turn the speaker system upsid
12Be sure to select wires, chains, and/or anchor shackles with asafety factor appropriate to the weight of the speaker system.Incorrect selection of t
[Direct wall mounting dimensions](Angle mode of 60°)408 (16 1/16)131 (5 5/32) 4-12 x 41 (4-15/32 x 1 39/64)546 (21 1/2)181 (7 1/8)6 (15/64)23 (29/32)U
1412. MOUNTING ON A POLEThe speaker can be mounted on a pole using the optional SP-131 Speaker Mounting Bracket in conjunctionwith the YS-60B Mounting
1513. MOUNTING BRACKET TYPESThe following mounting brackets are optional. Consult the instruction manual enclosed with each bracket for details on the
16. SPECIFICATIONSNote: The design and specifications are subject to change without notice for improvement. • AccessoriesSuspension bracket ...
2When Installing the Unit• Refer all installation work to the dealer from whom the speaker was purchased. Installation for flying requiresextensive te
3When Installing the Unit• Avoid touching the unit's sharp metal edge to prevent injury.• To avoid electric shocks, be sure to switch off the uni
4. ABOUT THE INPUT OVERLOAD PROTECTION CIRCUITRY The speaker system features internal input overload protection circuitry. If an extremely high input
56. DIMENSIONAL DIAGRAM[Top][Front]• HX-5B/5W Input Section • HX-5B-WP/5W-WP Input Section[Side][Rear]408 (16 1/16) 342 (13 15/32)546 (21 1/2)Unit: mm
8. INPUT SECTION8.1. HX-5B and HX-5W• The 2 Speakon connectors are internally connected in parallel to the screw terminals; you can use eitherone.• Th
79. CHANGING THE SPEAKER'S DIRECTIVITY ANGLEThe speaker system's directivity angle mode is factory-preset to 60°,but this mode can be change
8Step 3. Reposition the 4 bolts to the desired directivity angle, then retighten them securely. The sound coverage area can also be made asymmetrical
910. SUSPENDED INSTALLATIONThe speaker systems may be suspended either vertically or horizontally.Step 1. For vertical suspension: Remove the speaker
Kommentare zu diesen Handbüchern